Battery Tester Project Using LM3914 IC
This objective of this project is to design and build a battery tester that is able to test various types of dry cell and rechargable battery with a voltage of less than 2V. Configured as a bar graph battery level indicator, the LM3914 IC from National Semiconductor senses the voltage levels of the battery under test and drives the 10 LEDs to ON or OFF based on the voltage that is detected. The current driving the LEDs is regulated by using the external resistor R1 and hence limiting resistors are not required.
The schematic shows the simple connections where the reference voltage at pin 8 of U1 can be adjusted by adjusting the variable resistor VR1. The voltage at pin 8 will set the maximum scale of the LED. In testing dry cellbattery of 1.5V, set the voltage at pin 8 to 2.0V. Each of the LED will thus represent 200mV when lighted up.
If testing of rechargable battery such as NiCd or NiMH is required, set the reference voltage to a lower value such as 1.5Vas the typical voltage of a rechargable battery is approximately 1.2V.
When testing the battery, take note of the polarity of the probe to the terminals of the battery. T1 is to be placed on the positive terminal and T2 the negative terminal of the battery.
Parts List
The parts list of the project is as shown below.
Share this on your favourite network
Very good post. Appreciate it.
ReplyDeleteSome of good battery and Power supply related post can be also found here-http://www.amaderelectronics.com/power-supply